- Charging: Chargers, Solar Panels, Wiring
- Reention bike side battery power input connector
Reention bike side battery power input connector
Posted by Don on 2021 Dec 10th
I purchased this so that I could make a secondary use of my ebike battery. I use the connector to plug my 48v battery pack into my inverter to use for power outs. It works perfectly for this.
Posted by Lee Boerner on 2021 Nov 16th
Built great if never to be disconnected,there is no provision to disconnect unless you pull on the wires.
Posted by Frank on 2021 Oct 4th
Good cable gauge, fits perfectly. Now powering an inverter!
More than met expectations
Posted by jeff on 2021 May 21st
Part fit perfectly & corrected the loose connecter it replaced!
Perfect connector! Allows me to use ebike battery for inverter :)
Posted by Adrian on 2021 Jan 14th
We have 2 iGo ebikes with 48V batteries. With these connectors, I was able to wire in a 48v - 12vdc converter and then to a 12v - 120vac inverter, so I can use the ebike battery to power all sorts of equipment.
Pins not equal length
Posted by Jim on 2020 Aug 13th
The (+) pin is shorter than the (-) pin. Meaning less contact area for the shorter pin & a possible source of excess heat.
***Note from Hilleater***
The Reention connector is designed with 1 pin shorter.
Easy replacement piece
Posted by Fredrick Rondpre on 2020 Mar 6th
The wires became detached on my previous unit, so I replaced with this one. Works great, only issue was that I had to remove and replace the connecting wires, but the unit worked well.
Bike side power connector for Reention dorado battery system as used on Hilleater, Juiced and many other bikes. PLA0049 to XT60 female with 120mm 14ga wires.
The other use for this pigtail is to access the power stored in your ebike battery for other uses. Use a digital adjustable DC-DC converter to step down the voltage for use with 12V accessories, or 19V for your laptop etc. Great for power outages, or camping.
Reention connector is part # PLA0049